U disk to use the small details of the Note
U disk and are based on USB interface device with USB interface can be hot-swappable, but still need to master some skills. Into the need to pay attention in the direction of the case can not be inserted in the face, do not force, a change in direction can solve the problem. And not immediately after the disconnect and then to insert, wait 5 seconds or so and then insert.
U disk now has a lot of LED indicator lights, the LED lighting, flash and so reflecting the different state U disk, in general, when light is bright as long as U can not disconnect the drive, indicating that the U disk work force will pull out the damage. In Win98, only when the light is off, to remove U disk. U-disk for no lights, during read and write operation is complete etc waiting to be pulled out, so relatively safe. In Win ME/2000/XP, add U-hours more in the task bar icon for USB devices, open the icon will appear in the list U disk device, select the device disabled. Then you unplug the device, which would be more secure. It should be noted is that some U disk in WinXP under the light always on, this is because the WinXP on USB devices to increase the detection function, and as long as data traffic, light flashes, so this time also To disable the device, and then a pull out work. The choice of switch and floppy read and write like, U disk reading and writing are generally switch, switch the switch can control the U disk read-only and read-write. Many users use this switch, when used directly in the switch, which is not correct. Not only can the settings take effect, and there may be damage to U disk. The correct way is to unplug the U disk, then the state of the switch, and then insert U disk, in order to work properly. There are also some other U disk switch, should follow the steps above. Can not find the device. Sometimes we insert U after-hours, no response, then you must follow the following steps to be checked.
First, to determine whether properly inserted U disk USB interface, you can pull down and then plug the time; and then determine the version of your operating system to ensure the system is Win98SE or higher; check the BIOS settings in the system will activate the USB interfaces; If you have enabled USB device, but is not running properly, the solution is in the Device Manager to delete the "Universal Serial Controller" under the related equipment, and then refresh; Last check whether the driver U disk problems. If, after the above approach can not solve the problem, we recommend a computer in another test, if you still can not use, there may be a question of U disk itself, it is only to be replaced. Specific situation, I suggest you can check the use of U disk manual, or visit the U disk corresponding Web site.
Deutsch
Español
Français
Italiano
Português
日本の
한국어
العربية
български
hrvatski
česky
Dansk
Nederlands
suomi
Ελληνικά
हिन्दी
norsk
Polski
Română
русский
Svenska
中文
